If the washer was powered on before being connected to water the door may be locked and it may go into a drain mode.
Maxima maytag washer door locked.
The door is locked the pump is humming and the controls are all blank.
Replace the door lock switch if defective.
Unplugging for hours did nothing read more.
Clear any debris out of the door lock assembly.
Reconnect power to washer plug in.
After plugging the washer in one of the following 3 events will happen.
I have a maytag maxima front loader and it is doing exactly what the thread above is saying.
The door may immediately unlock.
Plug the appliance into a grounded 3 pronged outlet per the installation instructions.
Wait approximately 2 minutes for control to reset.
Once the washer door is closed the washer can begin operating.
If not call for service.
The door should unlock after this is complete.
Unplug the washer and check the door lock assembly for damage or a loose wiring connection.
If the door lock is defective the washer door will not latch properly.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Run a drain and spin cycle.
If the washer has an f8 e1 error or lo fl error the door will be locked and the control will be unresponsive.
The door can t lock.